MUTELCOR - OTA Configurator

Load current configuration

Retrieve the complete configuration by sending the 6 downloads 02710013, 02712328, 02714B28, 02717328, 02719B28 and 0271C328 (base64: AnEAEw==, AnEjKA==, AnFLKA==, AnFzKA==, AnGbKA== and AnHDKA==) to the device on port 1

Paste all configuration responses in Hex or base64:

Advanced

Setting	Current Value	Target Value	New Value	Adjust

LoRaWAN download

base64

Legacy

Additional SCD30 CO₂ sensor download commands

Forced Recalibration

NOTE: You need LoRaButton firmware version 1.4.4 or higher and a very good CO₂ reference to change the calibration, these commands are irreversible!

Make sure the CO₂ sensor is in a stable environment with the CO₂ reference very nearby and set the CO₂ level: (use the slider to specify the current CO₂ level) ppm

To force recalibration to CO₂ level ? ppm send the following download to port 1
After queueing the download in the LoRaWAN network immediately press the button on the CO₂ sensor to ensure the download is not delayed.